I'm building a Venice water taxiboat from scratch.
The hull has been build from triplex covered with mahagoni stripes.
There is still a lot of work to be done, but technics are working and I hope to get here on the water in the comming week.

About the sterndrive, I believe this drive originaly comes from Graupner (G for Graupner), but this compagny doesn't exist anymore, only there sender/receivers survived.
I purchased my Sterndrive with Bauer-Modelle.com.
The driver is from 3drifter-miniatures.de
My original drawings came from Gilberto Penzo in Venice, https://www.veniceboats.com/it-progetti-piani-barche-barche-a-motore.htm

Some progress with my taxi boat.
The steps make a nice detail. Implementing the windows was challenging: first the fittings and then gluing the "glass" without making a mess of it. I used a suction pen, used for handling SMDs, to hold and handle the glass.
Still need to add some handles and doors.
The boat is easy to steer, and the bow thruster is working fine.

Hello ian,

I purchased a plan from Gilberto Penzo . From this plan I only used the shape of the hull and the height of the cabin. The rest is copied from photos on the internet.
I have fitted a stern drive that is partly hidden in a flooded compartment behind the motor. In the rear, where the stern drive comes out of the hull, I designed a cover and 3D printed it.
With the stern drive I found that you have to grease it by appying grease into the small tube/pipe on top of the drive. This has nowhere been shown in any paper that I have seen.
Willem