Commenti

Accedi per commentare.

1. zooma🇬🇧Bronze

   Ammiraglio di flotta·1 anno fa

   I must open my Sea Urchin pack and take a look at it.
   The character full rudder that attaches to to outside of the transom is easy enough to hinge (I hope) but deciding where to place the operating rod to the steering servo will need some serious thought.
   I have never seen a radio controlled Sea Urchin in use, so I need to consider the options.
   The push/pull option with the operating shafts passing through the transom would be a good mechanical fix, but making them water - tight will be the problem !

   Piaciuto da Len1 and Redpopman and 1 other
2. ChrisF🇬🇧Bronze

   Ammiraglio·1 anno fa

   Be interesting to see how you tackle the rudder. That in my Faun, which is a similar design and I guess size was a bit of a challenge!
   
   Chris

   Piaciuto da Len1 and Redpopman Vedi tutto
3. Redpopman🇬🇧

   Chief Petty Officer 1st Class·1 anno fa

   four year later ! and I've dug out the Urchin to see if I can finish her off just the rudder and RC to go 🤔

   Piaciuto da Len1 and Madwelshman Vedi tutto
4. Redpopman🇬🇧

   Chief Petty Officer 1st Class·5 anni fa

   filler applied, now the sealer and sanding to do.

   Piaciuto da Madwelshman and Seanympth Vedi tutto
5. Redpopman🇬🇧

   Chief Petty Officer 1st Class·5 anni fa

   I'm going to give that a go today after testing it out on some scrap, I don't want o be lumbered with spending time removing a failed attempt again.

   Piaciuto da Madwelshman
6. Madwelshman🇬🇧

   Tenente comandante·5 anni fa

   A couple of the old/project boats that I have bought, people have used car body filler and built up above and below the shaft/around the keel and blended it away to nothing ahead of the tube exit point on the underside.
   Whether or not that's a recommended option these days I do not know, but I have a few like that.
   
   Will
7. NigelTailyour🇬🇧

   Master Seaman·5 anni fa

   I’m very pleased with my choice of two car colours. Ford Ivory White and a BMW Mini metallic Cosmic Blue.
8. NigelTailyour🇬🇧

   Master Seaman·5 anni fa

   I’ve just done a float test after an initial build like yours. It leaked!
   So I followed advice and used a two part epoxy on the outer joints of the prop tube. Then, having reduced the leaks a bit, I poured a tea cup of “Seal and Sand” IPE polyurethane wood glue. Any cheap white wood glue will work. Then over the next day I liberally brushed it all over the inside of the hull.
   No leaks and ready to paint.
   I hope that gives you a nice dry boat.

   Piaciuto da Redpopman
9. Redpopman🇬🇧

   Chief Petty Officer 1st Class·5 anni fa

   just having a few problems with the rather long exit of the prop shaft, try to get a smooth finish for the hull but the fibreglass option didn't work that well, have now removed it ?

   Piaciuto da Colin H
10. Madwelshman🇬🇧

    Tenente comandante·5 anni fa

    I haven't decided on what colours to do mine either yet.
    I've got plenty of time to decide though, got one or two others to get sorted first.